Haefely-EFT/Burst Verification Set EFT/Burst Verification Set for Verification of EFT/Burst Impulse according to IEC/EN 61000-4-4 Ed. 3 (set includes PAT 50A + PAT 1000)
EFT/Burst generators are verified according to the standard IEC/EN 61000-4-4 Edition 3. Measurements of individual impulse parameters are performed using a termination to match the EFT/Burst generator output impedance (50Ohm) and a voltage divider to reduce the impulse level so it can be displayed on commercial oscilloscopes.
The 50-Ohm attenuator, PAT 50 is to match the new edition 3 requirements. An oscilloscope with minimum 400MHz bandwidth is required to properly display the EFT impulse.
The PAT attenuator series has been developed in response to the IEC 61000-4-4 amendment 2 from 2001, which extends the verification requirement to also include impulse measurement using a 1kOhm load. The PAT 1000 meets the amendment 2 and edition 2 requirements of 1000Ohm in parallel with 6pF.'
EFT/Burst generators are verified according to the standard IEC/EN 61000-4-4 Edition 3. Measurements of individual impulse parameters are performed using a termination to match the EFT/Burst generator output impedance (50Ohm) and a voltage divider to reduce the impulse level so it can be displayed on commercial oscilloscopes.
The 50-Ohm attenuator, PAT 50 is to match the new edition 3 requirements. An oscilloscope with minimum 400MHz bandwidth is required to properly display the EFT impulse.
The PAT attenuator series has been developed in response to the IEC 61000-4-4 amendment 2 from 2001, which extends the verification requirement to also include impulse measurement using a 1kOhm load. The PAT 1000 meets the amendment 2 and edition 2 requirements of 1000Ohm in parallel with 6pF.'